Share Wisco832's profile
 
Facebook Twitter
 
 
Wisco832
  • Staff
 
 
 
Wisco832's stats
 
Reviews
  • Review count
    0
  • Helpfulness votes
    0
  • First review
    None
  • Last review
    None
  • Featured reviews
    0
  • Average rating
    0
 
Reviews comments
  • Review comment count
    0
  • Helpfulness votes
    0
  • First review comment
    None
  • Last review comment
    None
  • Featured review comments
    0
 
Questions
  • Question count
    0
  • Helpfulness votes
    0
  • First question
    None
  • Last question
    None
  • Featured questions
    0
 
  • Answer count
    428
  • Helpfulness votes
    102
  • First answer
    July 18, 2013
  • Last answer
    October 23, 2015
  • Featured answers
    0
  • Best answers
    3
 
 
Wisco832's Reviews
 
Wisco832 has not submitted any reviews.
 
Wisco832's Review Comments
 
Wisco832 has not submitted comments on any reviews.
 
Wisco832's Questions
 
Wisco832 has not submitted any questions.
 
Wisco832's Answers
1 2 3 4 5 ... 43 next>>
 
Stay in the saddle all day. The Harley Hammock Bucket Seat features in integrated suspension system that protects the rider and passenger's tailbone from harsh road impacts.
 

Seat Width?

The description says the Hammock seat width is 16" but under the fitment tab it says the seat width is 17". Which is it?
Hey BuffaloMark,
Thanks for your question. The Seat width is 17.0" and the passenger pillion width is 15.0". I've updated the data on the site. Sorry about that!

Hope this helps.
10 months ago
Customer avatar
by
Wisco832
 
Original Equipment on '06-later Dyna and '07-later Softail and Touring models, this Automatic Primary Chain Adjuster eliminates the need to manually adjust the primary chain tension at traditional service intervals.
 

Will this part fit a 2007 Road Glide ?

The fitment list on the main page says it will fit a 2007, but the years given only go as high as 2006.
Thanks, Dom
I Ride: Road Glide
Hey Dom22,
Thanks for your question! This part is actually stock (Original Equipment) on 2007-later Touring models. This is why the fitment only goes up to 2006 fitment tab.

Hope that helps!
10 months ago
Customer avatar
by
Wisco832
 
This low-profile fuel gauge replaces the analog readout with bright LED lamps. The six edge-mounted LED lamps glow blue when the tank is full, and extinguish one by one as fuel is consumed.
 

Will this work with my 2007 Heritage Softail Classic

I went into HD store and wanted to order this for my 07 Hertage softail classic. They told me it would not work on a 2007, only 2008 and up. Yet this site shows the fitment as it will fit. Will it or not.
Hey Rebel07,

Thanks for your question. Yes, Part Number 75095-05B will fit your 2007 FLSTC. It's Part Number 75098-08A that fits 2008 models and up.

Perhaps your dealer was looking at 75098-08A when they told you that it would fit 2008 and up.

Hope this helps!
10 months ago
Customer avatar
by
Wisco832
 
The compact Day Bag is perfect for the daily work commute. The innovative spandex mounting pocket makes installation and removal a simple process.
 

fitment

Can I mount the touring day bag to a detachable solo rack without a sissy bar ? Some or the reviews state that it flops around a lot . I'm not sure exactly how it mounts , as part of the description it would be good if it showed how to mount it . If it is going to flop around a lot I think that would be annoying . I would also like to know if it holds it's shape ? Thanks !! LA
I Ride: 2010 FXDC
Hey Lafxdc51,
Thanks for your question. Unfortunately you cannot mount this bag to a solo rack. It has to be mounted to a sissy bar. The straps on this bag actually mount around the sissy bar and it sits on the rack. The straps and sissy bar work in tandem to hold the bag in place.

The only bags in this collection that mount without a sissy bar are the Tail Bag P/N 93300069A and Tank Bag P/N 93300040 (which is for XL models).

With regards to shape, they do hold their shape, especially when packed full.

Hope that helps!
1 year ago
Customer avatar
by
Wisco832
 
Lifting your bike upright and off the side stand is ideal for cleaning and servicing, and reduces the space required for parking - handy where space is at a premium in a crowded garage, a small parking spot, or at a ride-in bike show.
 

Center Stand does not work on 2014 Limited (FLHTK)

The exhaust pipe and the stand are touching after installation. Also, the boots does not have enough space to properly hold the stand in place to lift the motorcycle. It is almost impossible to utilize this stand on my motorcycle. Is there anything been done to correct this error. The stand on the 2010-2013 did work great on my 2010. I have the stand that I purchased for my 2014 Limited, but cannot use it. Is there a recall on this center Stand?
I Ride: 2014 Limited FLHTK
User submitted photo
User submitted photo
Hey Rick23,
Thanks for your question. Check out the Installation Sheet located on the More Info tab. Page 2 indicates instructions for adjusting the exhaust crossover in cases where there is contact:
5. Verify that the display stand does not make contact with
the exhaust system. If the display stand contacts the
exhaust system, make the following adjustments in order
until contact is eliminated:
a. Adjust the foot pads to reduce the motorcycle display
height, if possible.
b. Loosen the display stand mounting hardware (Figure
1, items 1 and 2). Move the display stand as far forward
as possible. Tighten the mounting hardware to
specification.
c. See the service manual. Loosen exhaust system
mounting hardware. Move the exhaust system rearward,
if possible. It will not move far. Then tighten
exhaust system to specification.
6. Tighten the jamnuts securely.

Your dealer can give you a hand if you need further assistance.
1 year, 1 month ago
Customer avatar
by
Wisco832
 
Designed to provide extra touring comfort for the Road King rider.
 

the description states that this bar is 2" higher and 1.5" narrower. is this the difference between this bar and the standard bar on the 2014 RK?

I have a 2014 road king f l h r and want to compare the differences.
I Ride: 2014 road king
Hey Tana,
Yes, this is the difference between the Tallboy handlebar and the original equipment (stock) handlebar on the Road King. Hope that helps!
1 year, 3 months ago
Customer avatar
by
Wisco832
 
Nothing says minimalist like a classically simple drag bar.
 

Will these bars work on 2015 forty eight?

I was told at the dealer they will double checking..
I Ride: 2015 forty eight
Hey Rjluna82,
The fitment of this handlebar has been updated to fit XL1200X models. The updated fitment for XL1200X models requires separate purchase of Riser Spacer Kit P/N 55900074 and Turn Signal Relocation Kit P/N 67800489 or 67800452. All models require separate purchase of additional components. Check out the full fitment in the "Fitment Tab".
1 year, 4 months ago
Customer avatar
by
Wisco832
 
Comfortable nostalgic hourglass style with a chrome accent ring and a molded-in Harley-Davidson logo.
 

Just wondering if these grips eventually turn yellow? How long will they stay white?

I Ride: 1996 roadking and 2002 roadking
Hey Bubbleymonkey1,

These white grips are easy to clean! Simply use a clean, white cloth and Harley-Davidson® Wheel and Tire Cleaner, P/N 93600024, which will aid in removing any discoloration or stains. Rinse with clean water and dry thoroughly.
1 year, 7 months ago
Customer avatar
by
Wisco832
 
Stylish Harley-Davidson conchos can customize anything, from saddlebags and seats to tank pouches and tool bags. Includes Rosette & Lacing Strap.
 

how do the conchos get mounted no screws in my bag why is there no instructions

Hey vaughn71,

The concho attaches via the leather strap. You feed it through the concho, bag lid/flap and plastic retainer and then back out and through itself.

Hope that helps!
1 year, 7 months ago
Customer avatar
by
Wisco832
 
Combine the classic Harley-Davidson windshield shape with a revolutionary new attachment system, and you have the best of style and function.
 

Fairing pouch?

Will this work with the 3 pocket fairing pouch?
I Ride: FLHX
Thanks for your question! Unfortunately this windshield does not fit with the 3 pocket fairing pouch.
1 year, 9 months ago
Customer avatar
by
Wisco832